Subject:Volume tool

Posted by: Geoff_Wood

Date:4/19/2007 4:30:36 PM

Sometimes (only sometimes !) when I highlight a section and use Volume to reduce a glicth by, say 10 dB, repeatedly nothing happens. I then change the amount and the full new reduction happens immediately. Seems very intermittant.

geoff.

Subject:RE: Volume tool

Reply by: _TJ

Date:4/19/2007 6:15:18 PM

Most likely a failure to redraw. Some time when you don't see a change, try zooming in and out and see if the change appears.

tj

Subject:RE: Volume tool

Reply by: ForumAdmin

Date:4/20/2007 6:51:03 AM

Actually, it's most likely the default edge fades. Hit the "More..." button and make sure the fades are zero'ed. Then right click and select "Save Fade Options" to make that the default.

J.

Subject:RE: Volume tool

Reply by: Geoff_Wood

Date:4/21/2007 1:41:14 AM

I think it was the fades - I hadn't reset the default after a clean re-install. Fault didn't show up on a longer selection and when re-checking with attention to the fades, behaves OK..

geoff

Subject:RE: Volume tool

Reply by: rraud

Date:4/21/2007 4:03:27 PM

yeah Geoff, I posted a similar problem which has something to do with the (new) default volume cross-fade. I've been on location and have not tried the fix posted in that thread.
[url]http://www.sonycreativesoftware.com/forums/ShowMessage.asp?MessageID=521419&Replies=6